
A driveway that holds its color through every season
Driveway Paver Sealing in Dunedin, FL
Call (727) 493-9640 and a local contractor will quote sealing for your Dunedin paver driveway.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Who can seal my Dunedin paver driveway, and how soon?
A local contractor can seal your paver driveway in Dunedin, FL, and you hear back within 1 business day, often much earlier. The estimate is free and nothing is owed if you pass. Call (727) 493-9640 to start.
The driveway is the first thing a visitor sees and the paved area that takes the most abuse. Tires, oil, sun and sprinkler spray all land on it, so color fades first and weeds arrive next. Clean pavers with fresh sand and a protective coat fix both at once. Give the size and the roughest spots when you ask for a free estimate.
Why do Dunedin driveways fade and fill with weeds?
Sun does the fading and rain does the rest. Pinellas County summers reach the low 90s with near daily afternoon thunderstorms, and nearly two thirds of the year's rain falls from June through September, according to Wikipedia. Each storm washes a bit of sand out of the joints, and open joints let weeds and shifting begin. To find out how your seams look, call (727) 493-9640.
Salt adds to it near the water. Paver Sealing Pinellas says salt air drifts inland from St. Joseph Sound, Honeymoon Island and the Gulf, and that it wears down joint sand and color. Older homes near downtown and Douglas Avenue differ from newer streets near Curlew Road, but both sit under the same weather. Describe your street when you ask for a free estimate.

What does driveway paver sealing cost in Dunedin?
Rusty's Pro Wash and Seal publishes $1.25 to $2.50 per square foot for Tampa Bay, with a 1,000 square foot driveway at $1,250 to $2,500. Large projects can approach $1.00 per square foot, and jobs of 3,000 square feet and up run about $1.00 to $2.00. No page read for this guide gives a driveway-only rate, so the table applies the published range to common sizes. To price yours, ask for a free estimate.
Small jobs sit under a minimum charge of $500 to $1,000. Rusty's says surface condition matters more than material, so heavy oil, rust, lost sand and old failed sealer raise the price faster than the paver type does. Ask for the wash, the sand and the sealer as separate lines when you call (727) 493-9640.
| Driveway | Typical size | Clean, sand and seal at $1.25 to $2.50 | Note |
|---|---|---|---|
| One car | 400 sq ft | $500 to $1,000 | Minimum charge may apply |
| Two car | 600 sq ft | $750 to $1,500 | Common single family size |
| Wide or circular | 1,000 sq ft | $1,250 to $2,500 | Rusty's example: $1,250 to $2,500 |
| Long drive and walkway | 1,500 sq ft | $1,875 to $3,750 | Volume rates start near 3,000 sq ft |
Math based on the Tampa Bay range published by Rusty's Pro Wash and Seal. The final price comes from the contractor after a look at the surface.
How long before the car can go back on the driveway?
Premier Coatings says a typical driveway takes about a day, with larger ones 1.5 to 2 days. Feet can cross it after a few hours, but vehicles should stay off for 24 to 48 hours. Park on the street, tell the household and leave the garage door closed. To pick a day, call (727) 493-9640.
Unilock adds that pavers need a few hours of sun or about a day in shade to dry before sealer goes on, and that sprinklers must stay off while it cures. A driveway under an oak dries slower than an open one. Ask how the contractor plans the wash and the coat around that when you ask for a free estimate.
What should be fixed before a driveway gets sealed?
Sealing finishes a driveway but does not repair it. Unilock says sealer will not solve drainage or base problems, and that sealing over a failed coat or trapped moisture can leave a whitish film. Walk the driveway with the contractor and point at each trouble spot when you ask for a free estimate.
Oil and rust marks
Premier Coatings says oil, sunscreen and rust should be cleaned quickly. Rusty's warns that sealing over a stain traps it.
Sunken or wobbly pavers
A paver that has dropped needs the base repaired first. Sealer only coats the surface.
Sprinkler lines
Dunedin sends reclaimed water to some properties for irrigation. Overspray leaves mineral scale, so heads should be aimed off the pavers.
Old sealer
Unilock says an incompatible old product can cloud the new one. A contractor tests a small patch first.
Is driveway sealing different from general paver sealing in Dunedin?
The steps match the main paver sealing guide, but a Dunedin driveway has its own wear points: the apron where tires turn, the strip beside the garage door and the edge where lawn sprinklers reach. Dunedin contractors price the whole drive as one surface, so a single quote covers the apron, the runner strips and any front walk joined to it. To describe your Dunedin driveway, call (727) 493-9640.
If the drive is stained or green but the coat is not due, a wash and fresh sand may be enough. The paver cleaning and joint sand page covers that smaller Dunedin job, and the service areas page shows which nearby places share the same contractors. To compare the options for your home, ask for a free estimate.
Which finish works on a driveway?
Premier Coatings lists natural or matte, satin and gloss or wet look. On a driveway, tire grip is not a worry the way it is by a pool, so most of the choice is color. Wet look gives the strongest color depth, matte stays closest to the original paver, and satin sits between them. Ask to see each on a sample paver when you ask for a free estimate.
Think about the garage apron too. Unilock says high gloss can turn slippery when wet, and an apron that slopes toward the street is where a wet driveway matters most. A lower sheen is a sensible pick at the slope. Share the grade of your drive when you call (727) 493-9640.
How often should a Dunedin driveway be resealed?
Most Dunedin properties benefit from a coat every three to five years, according to Paver Sealing Pinellas, with full sun and water pulling toward three. Rusty's agrees and says covered areas can reach five or more. Premier Coatings is shorter, at two to three years in heavy sun and salt spray. To estimate your own, call (727) 493-9640.
The signs are simple. A driveway that darkens fast when wet, shows low joint sand or grows green film in weeks is asking for attention, Premier Coatings says. Two or more of those mean cleaning, sand and a new coat. Put your name on the schedule when you ask for a free estimate.

Which Dunedin neighbors can ask for driveway sealing?
A golf cart is street legal across about 60 percent of Dunedin under a 2011 ordinance, according to Wikipedia, so many driveways carry an extra set of small tires alongside the car. The city has 21,905 homes in all. Every place below has a page of its own, and a call to (727) 493-9640 reaches the same contractors.
What do sealed driveways look like around Dunedin?








What is the driveway sealing process from start to finish?
The driveway sealing process runs in six parts, drawn from the steps Premier Coatings and Paver Sealing Pinellas describe. To book it, ask for a free estimate.
1. Walk the drive
Measure, mark oil spots and dips, and test how the old coat reacts.
2. Wash and treat
Pressure washing is a required step, Paver Sealing Pinellas says. Algaecide and a full rinse follow.
3. Let it dry
A few hours in sun or about a day in shade, per Unilock.
4. Fill the joints
Fresh, often polymeric, sand goes in and the surface is swept clean.
5. Protect the edges
Plants, lights and the garage door edge are covered.
6. Flood coat
Sealer goes on in the planned finish, and vehicles stay off for 24 to 48 hours.
Frequently Asked Questions
How often should I seal pavers in Florida?
Plan on every three to five years, the span Unilock and Rusty's Pro Wash and Seal both give. Rusty's says a driveway in full sun leans toward three. Premier Coatings sets two to three in heavy sun and salt spray. Water that soaks in instead of beading is the clearest sign a coat is wearing thin.
What is the average cost to seal pavers in Florida?
Rusty's Pro Wash and Seal publishes $1.25 to $2.50 per square foot for Tampa Bay, and its example for a 1,000 square foot driveway is $1,250 to $2,500. Very large jobs can approach $1.00 per square foot, and a minimum charge of $500 to $1,000 can raise the price of a small one.
What is a good paver sealer for a Florida driveway?
That depends on the pavers, the finish you want and how much sun the drive gets. Unilock says some sealers need one careful pass and others two thin coats. Rusty's says brick often needs clay-formulated products. A contractor should name the product and the finish before the quote is signed.
How much is a paver driveway in Florida?
This page covers sealing, not installing. For sealing, Rusty's range is $1.25 to $2.50 per square foot to clean, sand and seal, so a 600 square foot drive is about $750 to $1,500. Laying a new paver driveway is a different trade and a different price.
How much does it cost to have pavers cleaned and sealed?
The published Tampa Bay range covers both together: $1.25 to $2.50 per square foot at Rusty's. Cleaning is built into that figure because Paver Sealing Pinellas calls pressure washing a required step before sealing. Ask whether the quote lists cleaning, sand and sealer as separate lines.
Is there a downside to sealing pavers?
The chief drawback is paying for a new coat every few years. Unilock also says high gloss can be slippery when wet and that a whitish film can show up from trapped moisture, too much product or an old coat that does not match. A contractor can explain how each is avoided.
Is it good to seal pavers in Florida?
Usually, yes. Unilock says sealer guards against water, dirt, oil and UV fading and can tighten the top of the joint sand so weeds find fewer places to start. Strong sun and heavy summer rain are the reasons it matters more here than in drier states, according to Rusty's.
Can I park on the driveway right after sealing?
Not for a little while. Premier Coatings says light foot traffic is fine after a few hours and that vehicles should stay off for 24 to 48 hours. Plan to park on the street or in the garage, and ask the contractor for the exact time for the product they use.
Will oil stains from my car be sealed in?
They can be. Rusty's warns that sealing over algae or stains traps them under the coat, and Premier Coatings says oil, sunscreen and rust spots should be cleaned quickly to avoid permanent marks. Point out every spot at the first visit so each gets its own treatment.
Does a long driveway cost more to seal?
Size drives the total, and the rate per square foot usually falls as the job grows. Rusty's says volume jobs of 3,000 square feet and up run about $1.00 to $2.00 per square foot, while small areas can cost more per foot because of the minimum charge.
Want a driveway that still looks fresh next summer?
Send the short form or call. A contractor answers within 1 business day, often well before.
Free, no obligation
